Introduction

Today’s oscilloscopes are extremely powerful tools with the ability to unearth minutely fine signal details. In no case is this truer than with the WaveSurfer 10 oscilloscope from Teledyne LeCroy. When equipped with the optional Advanced Debug Toolkit (ADT), the WaveSurfer 10 gains a number of debug and analysis tools such as History Mode, which allows users to scroll back in time to isolate anomalies or other waveform events, measure them with parameters or cursors, and quickly find the sources of problems.

Often, when viewing waveforms on an oscilloscope display, unexpected events may occur and there is no way for the user to stop the trigger and view anomalies. History Mode changes this and shortens the amount of time it takes to identify problems by automatically stopping the trigger and displaying a list of previously captured waveforms. In this way, unexpected anomalies can be viewed, quantified, and analyzed.

Invoking History Mode

For this demonstration, a 1-kHz, FM-modulated signal was input to Channel 1 on the oscilloscope. The initial oscilloscope setup is shown in Figure 1.

Figure 1:

This is the initial setup with a 1-kHz, FM-modulated waveform on Channel 1 of the WaveSurfer 10 oscilloscope

Users may access History Mode from the Timebase pulldown menu; tapping History in that menu brings up the History Mode dialog box. Checking the View History box at the dialog’s upper-left corner stops the trigger and quickly displays a list of previously captured waveforms alongside the waveform grid as shown in Figure 2.

Figure 2:

Checking View History in the History Mode dialog box brings up theHistory Mode table seen at top left. History Mode saves and shows all acquisitionsautomatically with the time at which they were acquired

Navigation within History Mode

The History Mode table is interactive in that tapping any line within the table automatically brings up that acquisition. Thus, by scrolling up or down the table, users have direct access to any acquisition. This can be accomplished either by manipulating the front-panel Adjust knob or by using the Waveform History Navigation section of the History Mode dialog box.

The Waveform History Navigation controls provide a flexible means of traveling backward and forward through the mass of acquisitions stored in memory. Seen in the dialog box shown in Figure 2, the Waveform History Navigation controls offers slow scrolling, fast scrolling, single stepping, and a second scroll bar.

The top row of controls regulates scrolling, with the two outer buttons initiating a fast scroll and the two inner buttons a slower scroll. On the bottom row, the outer buttons jump to the oldest and newest acquisitions, while the inner two step through one at a time. Tapping the Index box allows for direct numeric entry of the desired history item. At bottom is the manual scroll bar, which duplicates that seen to the right of the History Mode table in Figure 2. Also note that the Relative Times checkbox in the History Table section of the dialog box toggles the table between display of the absolute time of each acquisition and the relative time from the last acquisition.

Note that it is possible to save any displayed acquisition in History Mode by opening the File pulldown menu and selecting Save Waveform. Also, users may apply measurements or math operations to any selected History Mode acquisition as shown in Figure 3.

Figure 3:

Measurement and/or math operations may be performed on any acquiredwaveform in History Mode. In this example, the ninth acquisition is being measuredfor width, frequency, rise time (20-80%), duty cycle, and period. Note that the Measure dialog box, in which measurements are set up, now appears at bottom

Conclusion

The History Mode function in the WaveSurfer 10 oscilloscope provides a myriad of powerful analysis and debug options. History Mode automatically saves all acquisitions and delivers convenient means of navigating through a tabular list. Moreover, measurements and/or math operations may be performed on any historical acquisition.