Key Features
-
Supports Simple Data SPI, Dual SPI and Quad SPI
-
Flexible Configuration for Decoding
-
Powerful trigger helps to debug faster
-
Decode on analog, digital or any mixed combination of signals
-
Hex, ASCII, Binary and Symbolic decoding
Powerful trigger helps to debug faster (“T”)
Powerful protocol triggers on commands and/or addresses and data content simplify troubleshooting and help to understand the communication. The symbolic definition of command triggers is easy to set up and avoids errors.
Conditional DATA Trigger Setup ("T")
The trigger permits a conditional (<. <=, =, >, >=, <>, inside a range, outside a range) setup for the DATA condition. This is especially useful in situations where abnormal events should be monitored, such as when a CAN node broadcasts a low or high engine RPM or coolant pressure.
Trigger Flexibly Across Data Bytes("T")
Many software architectures are very message dense, and data for a single message is spread across multiple data bytes. Our QSPI trigger toolsets permit isolation of specific bit-level data patterns in one or more data bytes, e.g., data location in bits 18-26 in data bytes 2 and 3. This provides significant advantages in isolating the exact information or behavior you need.
Flexible Configuration for Decoding (“D”)
Flexible configuration allows decoding to be tailored to a wide range of implementations. QSPI-TD supports the configuration of transmission modes (Simple Data, Dual/Quad Data, Dual/Quad IO, Fast, DDR) as well as configuring address length, number of mode bits and dummy cycles.
Intuitive, Color-coded Decode Overlays ("D")
A transparent overlay with color-coding for specific portions of each protocol and the entire message frame makes it easy to understand your serial data information. Unlike other solutions, with protocol decode information away from the signal, our solution correlates the waveform and the protocol decode directly on the display. As the acquisition length is expanded or shortened, the decode overlay will adjust to show you just the right amount of information.
Interactive Table Summarizes Results ("D")
Turn the oscilloscope into a protocol analyzer with a tabular display of decoded information. Customize the table to show only the data of interest and touch a message in the table to automatically zoom to it and display it on the screen. Export the table for offline analysis. Up to four different decoded signals of any type may be simultaneously displayed in the table.